|
Post by parametric on May 16, 2017 13:52:55 GMT
This would certainly make editing a lot easier . . . . I'm sure most of you will have seen THIS video: Well, I emailed Erik and asked if he KNEW how the display shown was done . . . . This was his reply: So there it is . . . . It obviously IS possible, but it will take someone with more electronics savvy than me to fathom it out Any takers? parametric
|
|
|
Post by Jesse on May 17, 2017 14:07:13 GMT
Alesis Fusion affectionately known as "The Beast" Sounds like a job for Brian Allan at Sector 101
|
|
|
Post by kpr on May 19, 2017 6:26:16 GMT
This would certainly make editing a lot easier . . . . I'm sure most of you will have seen THIS video:... 1 Well, I emailed Erik and asked if he KNEW how the display shown was done . . . . This was his reply: So there it is . . . . It obviously IS possible, but it will take someone with more electronics savvy than me to fathom it out Any takers? parametric Perhaps one of the developers could provide more info about that. Taiho Yamada and Randy Lee for instance, they're on fb.
|
|
|
Post by parametric on May 20, 2017 0:39:46 GMT
That's a good suggestion Klaus - Thanks - I'll give it a try . . . parametric
|
|
|
Post by Jesse on May 20, 2017 2:49:01 GMT
Alesis Fusion affectionately known as "The Beast"
One key factor is possibly being limited to using a monochrome type monitor, a VGA LCD color monitor may or may not work.
I am currently researching the Fusion's display pin out's and the replacement Hantronix LCD display pin outs with a possible connection to a VGA connection by the 20 pin connection on the Fusion and/or USB to VGA.
I have ordered a USB to VGA adapter to test the Fusion, but do not have much hope in that working, although with the proper firmware it could, fingers crossed, the adapter should be here tomorrow.
Jesse
|
|