|
Post by deweak on Nov 27, 2006 13:17:13 GMT
Something quite annoying is the lack of a "dead zone" around the middle of the bender course. When I touch it a bit the sound instantly gets out of tune. Typically the variation is about few cents but it's disturbing.
All my other keyboards need a real bender movement to start the pitch effect, but the Fusion doesn't. I hope it will be solved soon. Should I contact the customer support ?
|
|
|
Post by mps on Nov 27, 2006 13:52:41 GMT
I have not noticed a problem with the pitch bender on my Fusion. Are you saying that it responds too quickly? That it should travel a bit before starting to change the pitch?
|
|
|
Post by deweak on Nov 27, 2006 14:01:02 GMT
Yes, the bender should be moved a bit more to have the bend effect active. But after all it's pretty cool for subtle manual vibrato effects.
|
|
|
Post by lildave2 on Nov 27, 2006 14:26:35 GMT
I have the same problem on my Fusion too. I wonder how a fix would have to happen.
|
|
|
Post by Hollow Sun on Nov 27, 2006 14:27:33 GMT
Something quite annoying is the lack of a "dead zone" around the middle of the bender course. When I touch it a bit the sound instantly gets out of tune. Typically the variation is about few cents but it's disturbing. There's a 'calibration' mode on Fusion that can fix this I believe. However, I can't remember how to access it (some key combo on power up ISTR) as I have never had the need to use it. Perhaps someone will be along to help. Steve
|
|
|
Post by markone on Nov 27, 2006 14:28:29 GMT
Never been a problem for me. It always drops back to being perfectly in tune if you let go. This is the behaviour I'd expect, to be honest
|
|
falcon
Junior Member
Posts: 130
|
Post by falcon on Nov 27, 2006 21:34:28 GMT
Holding 1+8 while powering on enters diagnostics mode. One of the sub-items here is calibration. Be careful with with some other options such as the disk-test here, as it wipes the hard-disk contents. (this is mentioned on screen, but is easily overlooked in a "heck what would this do" mood ;D).
|
|
|
Post by deweak on Nov 27, 2006 22:07:46 GMT
Great ! There is a pitch-bend center parameter where you can set the dead zone. Everything is ok now :-)
|
|
|
Post by Hollow Sun on Nov 28, 2006 0:18:55 GMT
Great ! There is a pitch-bend center parameter where you can set the dead zone. Everything is ok now :-) There ya go!! Steve
|
|
|
Post by Max on Dec 2, 2006 10:16:52 GMT
deweak what are the steps that you did to correct this? I have the same problem.
Thanks, Max
|
|
|
Post by lildave on Dec 2, 2006 13:55:26 GMT
I fixed mine yesterday. If I can do it, anyone can. Thanks for the help.
|
|