|
Post by kaluchie on Jan 21, 2007 8:52:53 GMT
Hello all,
I thought I'd come on in and see what all the fuss is about with this Fusion uber-synth! I don't have one yet, but I've arranged to demo one at a local music shop soon.
If it's alright with you, I'll be asking a few (very basic) questions about the Fusion so that I have some knowledge of it before I get to try it out.
Regards,
Stefan.
|
|
|
Post by Failed Muso on Jan 21, 2007 10:01:29 GMT
Hello all, I thought I'd come on in and see what all the fuss is about with this Fusion uber-synth! I don't have one yet, but I've arranged to demo one at a local music shop soon. If it's alright with you, I'll be asking a few (very basic) questions about the Fusion so that I have some knowledge of it before I get to try it out. Regards, Stefan. That's absolutely fine What I would say is that you ensure the one you demo has been upgraded to the latest OS (1.24). And make sure you spend plenty of time with it. Also, make sure it's hooked up to a decent amp or set of cans. Better still, take your own If this sounds like I am making excuses for the Fusion, that's not the case, but in the musical retail sector, there is extreme bias towards "the big 3" with many stores using staff on the payroll of some of those manufacturers. Therefore this means that products like the Fusion are left to languish in the back corner because they won't earn the commission on selling one. Good luck and make sure you use this resource. It's a goldmine
|
|
|
Post by kaluchie on Jan 21, 2007 10:07:50 GMT
Thanks for the welcome! I'll post some questions in the other section soon.
|
|
|
Post by mps on Jan 21, 2007 18:31:07 GMT
Stefan, Download the Quickstart Guide (link located on main page here under documentation) and read through it before you go. That way you will know how to change patches and play with the ARPS and filters and get into the programming menus.
|
|
|
Post by kaluchie on Jan 21, 2007 18:53:43 GMT
Stefan, Download the Quickstart Guide (link located on main page here under documentation) and read through it before you go. That way you will know how to change patches and play with the ARPS and filters and get into the programming menus. Thanks for the suggestion. I've already downloaded the quickstart guide (and the full manual) and I've been absorbing as much info as I can about the Fusion. Can't wait to demo one though.
|
|